beautypg.com

Event log, Date>

background image

Setting up your Unit

Ethernet Tester Analyzer

29

Unit Setup

Event Log

Event log provides events messages display in the ETS-1000. Setup Log
menu and also in console terminal by connection to the device via
USB-interface and by remote control via TELNET protocol.

Logged events are listed below:

start/stop of the test;

Loopback mode is switched on/off;

change of connection state;

remote test is running;

device is switched on/off;

low battery.

If one of these events occurred, the following message will be displayed in
the console terminal/Log menu.

For example, if you switch on Loopback mode at the 2nd layer on port B,
the following message will be displayed:

By default the function of messages displaying via USB interface and via
TELNET protocol is switched off. To switch on/off use log on/off remote
control command.