Eurocom M620NC TITANIUM - Manual (Page 82)

BIOS Utilities
5 - 14 Power Menu
5
Start Battery Calibration (Power Menu)
Press Enter to start the battery calibration process. The system will prompt you to
plug-in the AC/DC adapter and will begin to charge the battery to full capacity.
Once the battery has reached full capacity you will then be prompted to remove the
AC/DC adapter with the computer left on. This will completely discharge the bat-
tery. Once the computer has turned off the battery will be fully discharged.
Plug-in the AC/DC adapter and allow the computer to fully recharge the battery.
You may work on your computer as the battery charges, however if the computer is
powered on, and in use, it will take several hours to fully recharge the battery. When
the computer is turned off but plugged into an electrical outlet, battery charge time
is less. While the battery is charging the battery LED
will be orange; when the
battery is fully charged the LED will be cleared.