Echelon NodeBuilder FX/PL Examples - Manual (Page 12)

4 Using the NodeBuilder FX/PL Example
Using the Pre-Built Example Device Application
You can use the LonMaker tool to download the NcExample device application to the LTM-10A
Platform and install it in a L
ON W ORKS network. To do this, you restore the NcExa.zip file in the
LonWorks\NeuronC\Examples\NodeBuilder LTM-10A\Database folder, load the pre-built binary
application image file (.apb extension) for the NcExample application to the device, and then
commission the example device. After you install the example device, you can use the I/O devices on
the Gizmo 4 I/O Board and observe how network variable values are updated.
Restoring the LonMaker Network Backup
To restore the LonMaker network backup, follow these steps:
1. Connect your LTM-10A and Gizmo 4 I/O Board following Chapter 2 of the NodeBuilder User’s
Guide or the Quick-Start Guide included with your NodeBuilder FX/PL Development Tool.
2. Verify that you have installed and activated the LonMaker tool following Chapter 2 of the
LonMaker User’s Guide.
3. Start the LonMaker tool. To do this, click Start on the taskbar, point to Programs, point to the
Echelon LonMaker folder, and then click LonMaker. The LonMaker Design Manager opens.
4. Click Restore. The Select Backup File dialog opens. Browse to the
LonWorks\NeuronC\Examples\NodeBuilder LTM-10A\Database folder, and then double-click the
NcExa.zip backup file (.zip extension).
5. The Confirm Restore dialog opens.