Echelon i.LON 1000 Internet Server - Manual (Page 16)

12
i .LON 1000 Internet Serve Starter Kit
c) Get a static IP address, subnetmask, and default gateway address from
your TCP/IP system administrator.
Important: It is critical that you select an IP addressing
scheme that is compatible with your local TCP/IP network.
Check with your system administrator; do not use an IP
address until you have confirmation that it will not
adversely affect your local network.
The example addresses provided below are probably
incorrect for your local network. We provide them so that
you may understand the syntax of each command only.
Issue the following console commands at the command prompt to set the IP
properties of the
i
.LON 1000.
The syntax for console commands is: command argument
See your network administrator if you need help deciding on proper values
for the fields listed above. The hostname property can be a single name
without domain information, such as
ilon1
. It does not need to be a fully
qualified host name like
ilon1.echelon.com
.
d) Several of the commands entered above will not take effect until the
i
.LON
1000
is rebooted. Reboot the
i
.LON 1000 by typing reboot at the
i
.LON
1000
command prompt.
e) Once the
i
.LON 1000 reboots, type show at the
i
.LON 1000 command prompt
to verify that the changes were accepted and that there are no typographical
errors.
Type help at the
i
.LON 1000’s command prompt at any time for a list of
available commands.
ipaddress address Modifies the IP address, e.g., ipaddress 10.1.0.170
subnetmask address Modifies the subnet mask, e.g., subnetmask 255.255.255.0
hostname name Modifies the host name of the i
.LON 1000
, e.g., hostname myilon
(this name then becomes the console application prompt)
gateway address Modifies the gateway address e.g., gateway 10.1.0.1
ftpuser name Sets the FTP user name to name for security in using FTP, e.g.,
ftpuser user1 . Anonymous FTP is not supported.
ftppassword password Sets the FTP password to password, e.g., ftppassword gh5bug