Ditch Witch RT100 - Manual (Page 84)

RT100 Powershift Operator’s Manual
Trench - 83
Setup
CMW
1. If using optional trench cleaner, remove bolt installed for transport.
2. Fasten and adjust seatbelt.
3. Start tractor. See page 68 for start-up procedures.
4. Drive to starting point. Move in line with planned trench. See page 70 for driving procedures.
5. Apply service brake.
6. Engage parking brake and verify parking brake indicator is on.
7. Release service brake.
8. Move F-N-R lever to neutral.
9. Move dig/drive control to dig position.
10. Twist F-N-R lever to 1 (low).
11. Lower backfill blade.
12. Tilt steering column up.
13. Turn seat to the desired position.
14. Engage axle lock.
15. Lower boom to just above ground.
16. Check that boom is in line with planned trench.