Ditch Witch RT100 - Manual (Page 128)

RT100 Powershift Operator’s Manual
Service - 127
250 Hour
Check Transmission Fluid Level
Check transmission fluid level at dipstick (1)
before operation and every 250 hours thereafter.
Follow these steps:
1. Start engine and run at low idle for 3-5
minutes or until transmission fluid reaches 50-86°F (10-30°C).
2. With engine running, transmission in neutral, and fluid at this temperature, fluid level should be at the
COLD line on the dipstick.
3. Add PTF at fill (1) as necessary to keep fluid level at COLD line on dipstick.
NOTICE:
• Transmission damage can occur if fluid is
not maintained to the correct level.
• Use only Ditch Witch-approved Phillips 66
Torque Fluid transmission fluid. Do not
substitute any other transmission fluid.
IMPORTANT:
• With transmission fluid at normal operating temperature, (176-212°F/80-100°C), fluid level
should be at the HOT line on the dipstick.
• If transmission fluid temperature falls between the two ranges listed, fluid level should fall
proportionally between the COLD and HOT lines on the dipstick.