Control functions, On / off, Mode – Bonaire LV User Manual
Page 9: Navigating the controls
Multi-Appliance Manual Control
Navigating the Controls
CONTROL FUNCTIONS
ON
/
OFF
When pressing the ON / OFF button to turn the unit
on, the manual control will return to the last used
setting.
When unit is turned on the last used appliance will
be activated. This control is capable of controlling
the following Climate Technology Products
installed with PNE control systems:
•
Ducted Gas Central Heating
Number Description
•
Dual Cycle Ducted Gas Central Heating and
Dual Cycle Refrigerated Air Conditioning
1 Mode
Functions
2
12 Hour Clock
•
Ducted Evaporative Air Conditioning
3
ON / OFF
•
Ducted Gas Heating and Ducted Evaporative
Air Conditioning
4 Function
Symbols
5 Temperature
MODE
Press the MODE button to cycle through the available mode options. Only the modes relative
to the unit installed will be displayed.
• COOL – (Evaporative Air Conditioning) Pump Only. This function will allow you to
manually pre wet the filter pads by running the pump only.
• FRESH AIR - Fan only (Evaporative AC). This means the fan only can be run and the
fan speed adjusted via the UP / DOWN buttons.
• COOL FRESH AIR – The fan and pump will operate together with an evaporative air
conditioner.
• HEAT - Thermostat will control the unit via a temperature sensor. The comfort level can
be adjusted using the UP / DOWN buttons to increase or decrease the SET TEMP
amount of heating required.
• Fan Only (Heating Mode) – Only the fan symbol and the bar scale will be activated during
fan only mode. This allows the fan to operate without any heating functions.
• COOL – (Dual Cycle Refrigeration) Thermostat will control the unit via the temperature
sensor. The comfort level can be adjusted using the UP / DOWN buttons to increase or
decrease SET TEMP. The fan will run while the condenser cycles on and off.
• Continuous fan – (COOL Dual Cycle Refrigeration) The fan symbol will be displayed in
addition to the COOL and snow flake indicating the fan will run continuously while the
condenser cycles on and off.
Bonaire Control Systems
Page 9