Bonaire LV - Manual (Page 34)

Multi-Appliance Manual Control
Controls – Installation / Setup / Commissioning
EVAPORATIVE AIR CONDITIONING SETUP
Fan Speed Options
Installer Maintenance Default Value Range
Low Fan Speed 13 0 – 35
High Fan Speed 35 0 – 35
S ETTING THE F AN S PEED
Setting of the fan speed should be done by a Climate Technologies trained installer or service
provider. If the motor fan speed is set too low and a motor burnout occurs, Climate Technologies
reserves the right to charge the customer for the cost replacement.
To adjust the minimum fan speed setting
STEP 1 Turn the control ON and select COOL FRESH
AIR.
STEP 2 Using the DOWN button, adjust the fan speed
to the lowest setting.
STEP 3 Press and hold the ON / OFF button and the
DOWN key for 8 Seconds.
The default low fan speed will be displayed.
STEP 3 Using the UP / DOWN buttons, adjust the low
fan speed setting between 1 - 35. The new
speed will be saved within 3 seconds of the
last change.
STEP 4 To exit press the ON OFF button
or
To adjust the high fan speed, press the
MODE button.
The default high fan speed will be displayed.
STEP 5 Using the UP / DOWN buttons, adjust the
high fan speed setting between 1 - 35. The
new speed will be saved within 3 seconds of
the last change.
NOTE: Using the MODE button you can
toggle between high and low fan speed
settings.
STEP 6 To exit press the ON OFF button.
Note: Each time the fan speed adjustment is used, the fan speed will revert
to the default setting, not the last saved setting.
.
Bonaire Control Systems Page 34