Bonaire LV - Manual (Page 13)

Multi-Appliance Manual Control
Ducted Gas Central Heating
Congratulations on purchasing this ducted gas central heating system, an exciting new product
manufactured by Climate Technologies.
Wholly designed and manufactured in Australia, this Ducted Gas Central Heater represents an
exciting new development in warm air furnace design. It embodies the latest advances in gas
heating technology.
Your heater is supported by Climate Technologies, Australia’s most advanced manufacturer of a
complete range of climate control products.
To ensure you fully enjoy the benefits of this Ducted Gas Central Heater, please read these
instructions carefully and keep them handy for future reference.
Operated and maintained in accordance with this manual, this unit will provide you with years of
warm and environmentally friendly operation. Please take the time to read this manual.
SAFETY
S AFETY & O WNER R ESPONSIBILITY
The manufacturer and its service providers reserve the right to refuse service unless safety and
accessibility to the unit can be guaranteed. The cost of any extra equipment required to provide
access to the unit for servicing is the responsibility of the owner.
P RECAUTIONS .
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
DO NOT PLACE ARTICLES IN FRONT OF OR OVER THE RETURN AIR GRILLE.
F EATURES .
Your Ducted Gas Central Heater has all the safety devices to ensure safe operation. These
devices conform to the standards set out by the Australian Gas Association.
P OWER OR G AS INTERRUPTION .
Should there be an interruption to the power supply during the heating operation the controls will
automatically turn off the gas.
When the power is restored, the control will be in the OFF position and therefore will not resume
operation until turned ON.
Should there be an interruption to the gas supply, the heater will endeavor to re-light 3 times and
if unsuccessful will lock out. (This is part of the safety features). Should this occur the heater will
need to be reset. If the Err is displayed, turn the control OFF then ON and the unit will be ready
to resume operation.
Please refer to your problem-solving chart to assist resolving other problems.
Bonaire Control Systems Page 13