Bonaire LV - Manual (Page 20)

Multi-Appliance Manual Control
Dual Cycle – Refrigerated Air Conditioning
GENERAL INFORMATION.
I MPORTANT N OTICE .
A licensed person is required to install Climate Technologies equipment. If the equipment is not
installed in a accordance with the installation instructions and the governing body regulations,
Climate Technologies reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the
electrical and plumbing connections certifying that the work complies with all the relevant
standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D ATA L OCATION .
Your appliance model number, serial number and model description are located on the appliance
data plate on the end of the ducted gas heater / Dual Cycle air conditioner in the vicinity of the
electronic controls access. These details should also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you
require additional information about this product.
A SSEMBLY .
There is no assembly required of this Add-on Refrigerated Air Conditioner. Your Dealer or
installer will carry out all assembly and commissioning upon installation .
SAFETY
S AFETY & O WNER R ESPONSIBILITY
The manufacturer and its service providers reserve the right to refuse service unless safety and
accessibility to the unit can be guaranteed. The cost of any extra equipment required to provide
access to the unit for servicing is the responsibility of the owner.
P RECAUTIONS .
DO NOT PLACE ARTICLES ON OR AGAINST THE CONDENSER.
DO NOT PLACE ARTICLES IN FRONT OF THE CONDENSER.
ENSURE THE CLEARANCES BETWEEN THE UNIT AND WALL ARE KEPT CLEAR.
DO NOT PLACE ARTICLES IN FRONT OF OR OVER THE RETURN AIR GRILLE.
F EATURES .
Your Ducted Gas Central Heater and Add-on Refrigerated air conditioner has all the safety
devices to ensure safe operation. These devices conform to the standards set out by the
Australian Gas Association.
P OWER INTERRUPTION .
Should there be an interruption to the power supply during the cooling operation the controls will
automatically shut down.
When the power is restored, the control will be in the OFF position and therefore will not resume
operation until turned ON.
Bonaire Control Systems Page 20