Bonaire LV - Manual (Page 6)

Multi-Appliance Manual Control
Introduction
Introduction
GENERAL INFORMATION.
I MPORTANT I NSTALLATION N OTICE .
A licensed person is required to install Climate Technologies equipment. If the equipment is not
installed in a accordance with the installation instructions and the governing body regulations,
Climate Technologies reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the
electrical and plumbing connections certifying that the work complies with all the relevant
standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D ATA L OCATION .
Your appliance model number, serial number and model description are located on the appliance
data plate on the end of the heater or inside the cooler in the vicinity of the electronic controls.
These details should also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you
require additional information about this product.
W ARRANTY
Warranty service work must only be carried out by Climate Technologies service division or its
authorised service providers. See warranty section.
A SSEMBLY .
There is no assembly required of these Ducted Heating or Cooling products. Your Dealer or
installer will carry out all assembly and commissioning upon installation
.
Bonaire Control Systems Page 6