Bonaire LV - Manual (Page 26)

Multi-Appliance Manual Control
Ducted Evaporative Air Conditioning
OPERATING THE MANUAL CONTROL.
To operate your control simply press the ON OFF button. The unit will then display the default or
last used settings and will be ready to operate. Any changes made to the control settings will have
a 3 second delay before the unit responds.
If the evaporative cooler is connected in conjunction with a central heater you may have to toggle
through the modes to select the evaporative cooling functions
To select the one of the modes below, simply push the mode button until the screen displays the
required settings. The following modes are available for evaporative air conditioning.
COOL M ODE
Cool mode is pump only. This function is ideal when you want to run the pump to wet the filter
pads before turning of the fan. To select COOL:
STEP 1 Press the ON / OFF button to turn the
unit on.
STEP 2 To select COOL (Pump only) press the
MODE button until COOL is selected.
The pump will begin to operate and the
water droplets will appear on the
screen.
If COOL FRESH AIR mode is not
selected within 15 minutes the control
will turn off.
STEP 3 To turn the pump off press the ON OFF
button.
COOL FRESH AIR M ODE
COOL FRESH AIR is the pump and fan operating together giving cool fresh air. To select COOL
FRESH AIR:
STEP 1 Press the ON / OFF button to turn the
unit on (if not already on).
STEP 2 To select COOL FRESH AIR (Pump
and Fan) press the mode button until
COOL FRESH AIR is displayed. The
pump and fan will begin to operate
within 3 seconds.
The screen will display the water
droplets for pump, the fan and the bars
for the fan speed.
STEP 3 To adjust the fan speed use the UP
DOWN buttons. The bar will increase
of decrease indicating the nominal fan
speed. There is a 3-second delay
before the new setting is accepted.
STEP 4 To turn the pump and fan off press the
ON OFF button.
Bonaire Control Systems Page 26