Bonaire LV - Manual (Page 11)

Multi-Appliance Manual Control
Navigating the Controls
R ESET
The reset function is only required if the system has
had a problem and reports a fault code. This will be
indicated with Err and F1:_ _. The requirement for
reset will generally only appear with ducted gas heating
if there has been some form of electricity or gas
interruption.
To RESET the unit, turn the control OFF then ON. If
the unit does not reset call for service.
CLOCK S ETUP
To set the 12 hour clock
STEP 1 Turn the control to OFF
STEP 2 Press the UP or DOWN button until the
2 dots are solid to enter clock setup
(approximately 3 seconds).
STEP 3 Using the UP button to adjust the
hours.
STEP 4 Using the DOWN button to adjust the
minutes.
Time setup is now complete. Turn
control ON to resume operation of your
product.
F AULT C ODES
The manual control can recover the last 4 faults that the
unit diagnostics has stored.
When a product fault has occurred that requires the unit
to be reset, the last fault will be displayed on the screen
automatically. This will be in addition to the 4 faults
already held.
Should you require a service call on your product
please have this code ready for our service operator.
To reset the unit and clear the fault, simply turn the
control OFF then ON. Where possible the unit will
resume operation immediately
.
Bonaire Control Systems Page 11