American Energy Systems Country Flame Little Rascal User Manual
Page 29
29
INSTALLATION / INSERT UNIT / POSITIONING
1. The LR-01 insert is designed to be inserted into an existing masonry fireplace or zero clearance box.
The suitability of the existing firebox needs to be determined. You should insure that the heater is kept
out of any traffic paths in the room, away from curtains, drapes or any other combustibles. You should
also check that the existing fireplace was placed in a position where heat will be evenly distributed
throughout the room.
2. If the existing fireplace is found to be suitable, the LR-01 may be installed using zero clearance.
3. While installing the LR-01, verify that the location will not interfere with the circulation airflow. The
unit draws air from the grills on both sides of the unit.
4. The heater should be installed in such a manner so that the front of the unit remains unblocked. This
will allow for needed service and maintenance to the unit, and provide access to the firepot cleanout.
Mantel
or
Combustible
CLEARANCES FOR INSERT:
B
DIMENSIONS:
A = 3”
B = 6” A
C = 6”
C
FIGURE 7: INSERT MINIMUM CLEARANCES
Side Wall
INSERT
Hearth Extension