American Energy Systems MF3573 Auger Motor - Manual

MF3573 Auger Motor Assembly
All Magnum Countryside units and 7500 (from 2006 to present)
(1) MF3573 Auger Motor
(1) FAN3573CN Fan Blade
motor shaft
• Carefully remove from packaging.
• Mount fan blade to the motor shaft by gently pressing the fan blade onto the shaft. (must
be flush as shown).
F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3573 Auger Motor.doc
Make sure shaft is flush to blade.
metal collar towards motor
• Turn off power on control panel and unplug from the power supply.
• Open right side panel.
• Disconnect the auger motor leads from the wire harness.
• Loosen allen screw on auger shaft collar w/ set screw.
• Pull off auger motor.
• Slide the shaft collar back on auger shaft,
aligning the set screw to hole on the auger
shaft. Tighten the screw only enough to keep
it from slipping off the shaft.
set screw