American Energy Systems PP-1030-LR Wire Harness - Manual

F:\AESBusinessSystems\AES Technical\Piece part instructions\PP-1030-LR Wire Harness Assembly LR01.doc
Wire Harness Assembly
Part #PP-1030-LR
For Models LR-01 (prior to 2011)
• Unplug unit.
• Open both side panels.
• Remove existing wire harness.
• Attach the following:
o
Control Board molex connector
o
Exhaust Fan gray/white & black molex to black leads
o
Auger Motor brown/white & black to black leads
o
Room Air Fan blue/white & black molex to black leads
o
Vacuum Pressure Switch green lead to top terminal violet lead to bottom terminal
o
High Limit Snap Disk gray lead to top terminal violet to bottom terminal
ƒ all white snap disk
o
Snap disc right side yellow wire to top terminal violet wire to bottom terminal
ƒ yellow & white snap disk
o
Proof of Fire Snap Disk brown wire to top terminal violet wire to bottom terminal
o
located by exhaust motor yellow & white snap disk
o
Electrical Plug double white wires middle terminal black wire bottom terminal
green wire to top terminal other end of green wire screwed to base
of unit
o
Igniter red wire to one lead white wire to one lead
o
thermostat blue lead and red lead (these are not used if NO thermostat)
• Plug unit in
• Turn on unit