American Energy Systems RP2063 AC Wire Harness - Manual

F:\AESBusinessSystems\AES Technical\Piece part instructions\RP2063 Wire Harness AC.doc
Wire Harness Assemble AC
Part #RP2063
for Models Baby AC, Win AC, Essex AC & T40 AC
• Unplug unit
• Open both side panels.
• Remove existing wire harness.
• Attach the following:
o
Control Board molex connector
o
Exhaust Fan white wire to one lead blue wire to one lead
o
High Limit Snap Disk two orange wires to both leads
o
Vacuum Pressure Switch two grey wires to both leads
o
Proof of Fire Snap Disk two brown wires to both leads
o
Auger Motor white wire to one lead yellow wire to one lead
o
Room Air Fan double white wires to one lead pink wire to one lead
o
Electrical Plug double white wires towards the inside terminal
black wire towards the outside terminal
green wire to bottom terminal other end of green wire screwed to
base of unit
o
Igniter red wire to one lead white wire to one lead
ƒ (these are not plugged into anything if there is not an igniter)
N.O.
3
N.C.
2
COM
1
Attach one grey wire to ‘Com
1’ and one grey wire to ‘NO 3’.
Attached hose to back
connection ‘L’.
RT080 World Magnetics
Vacuum Pressure Switch
Attach one grey wire to ‘Com 1’
and one grey wire to ‘NO 3’.
Attached hose to bottom connection
‘P2’.
RT080 Clark Controls
Vacuum Pressure Switch
N.O.
3
N.O.
2
N.O.
1