American Energy Systems NPS-1005-N-7 Control Panel - Manual

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-7 Control Panel Kit LR New
Stlye.doc
Control Panel Kit LR New Style
Part #NPS-1005-N-7
For Models LR01 (2011 to present)
• Unplug unit
• Open both side panels.
• Remove existing wire harness and control panel
• Attach the following:
o
Control Board molex connector and black lead to terminal
o
Snap disc right side not used
o
Exhaust Fan white wire to one lead blue wire to one lead
o
High Limit Snap Disk two orange wires to both leads
o
Vacuum Pressure Switch two grey wires to both leads top terminal and middle terminal
o
Proof of Fire Snap Disk two brown wires to both leads (closes to the exhaust blower)
o
Auger Motor white wire to one lead yellow wire to one lead
o
Room Air Fan double white wires to one lead pink wire to one lead
o
Electrical Plug double white wires middle terminal black wire bottom terminal
green wire to top terminal other end of green wire screwed to base
of unit
o
Igniter red wire to one lead white wire to one lead
ƒ (these are not plugged into anything if there is not an igniter)
• Plug unit in
• Turn on unit
Molex