ADLINK cPCI-6S10 - Manual (Page 68)

58 Hardware Platform Management
Example:
Get SDR use raw command.
List all SDR from IPMC (from Device SDR)
Request Fields
root@BCNMB-A:~# ipmitool -I lan -H 127.0.0.1 -U
admin -P admin raw 0xa 0x22
06 00
root@BCNMB-A:~# ipmitool -I lan -H 127.0.0.1 -U
admin -P admin raw 0xa 0x23 0x6 0x0 0 0 0
10
01 00 00 00 51 12 13 20 00 cc 29 00
root@BCNMB-A:~# ipmitool -I lan -H 172.20.5.225
-U admin -P admin -t 0xB4 sdr list all
BMC_WatchDog | 0 unspecified | nc
POWER_GOOD | 0 unspecified | cr
P1V | 1.01 Volts | ok
P1V2 | 1.20 Volts | ok
P1V5 | 1.50 Volts | ok
P0V75 | 0.74 Volts | ok
+3.3V | 3.32 Volts | ok
+5.0V | 5.05 Volts | ok
54685_TEMP | 34 degrees C | ok
56150_TEMP | 47 degrees C | ok
1 Reservation ID. LS Byte. Only required for partial reads with a non-
zero ‘Offset into record’ field. Use 0000h for reservation ID
otherwise.
2
Reservation ID. MS Byte.
3
Record ID of record to Get, LS Byte
4 Record ID of record to Get, MS Byte
5
Offset into record
6
Bytes to read. FFh means read entire record.