ADLINK cPCI-6S10 - Manual (Page 45)

Hardware Platform Management 35
cPCI-6S10
Get Device SDR
Example:
List all SDR from IPMC (from Device SDR)
Request Fields
ipmitool ipmitool [parameters] sdr list all
Terminal mode [10 00 21 00 00 00 00 00 FF]
Description
This command is used to get SDR info. SDR format
depends on IPMI spec.
Ipmitool support sdr command to read those data. We
can use “ipmitool sdr” to get those data without pain.
If MC support “SDR repository device”, ipmitool will use
“SDR repository” first.
When MC only support “Sensor Device”, this command
has been applied to retrieve SDR.
We fix ipmitool to support list SDR from Device SDR with
“list” command.
root@BCNMB-A:~# ipmitool -I lan -H 172.20.5.225
-U admin -P admin -t 0xB8 sdr list all
cPCI-6S10 | Dynamic MC @ B4h | ok
BMC_WatchDog | 0 unspecified | nc
POWER_GOOD | 0 unspecified | cr
P1V | 1.01 Volts | ok
P1V2 | 1.20 Volts | ok
P1V5 | 1.50 Volts | ok
P0V75 | 0.74 Volts | ok
+3.3V | 3.32 Volts | ok
+5.0V | 5.05 Volts | ok
54685_TEMP | 48 degrees C | ok
56150_TEMP | 66 degrees C | nc
1 Reservation ID. LS Byte. Only required for partial reads with a non-zero
‘Offset into record’ field. Use 0000h for reservation ID otherwise.
2 Reservation ID. MS Byte.
3
Record ID of record to Get LS Byte. 0000h returns the first record
4
Record ID of record to Get, MS Byte.
5 Offset into record