ADLINK cPCI-6S10 - Manual (Page 43)

Hardware Platform Management 33
cPCI-6S10
Get Event Receiver
Response Data Fields
Note: The commands “Set event receiver” and “Get event
receiver” are used for event delivery between IPMC and CMM.
Other address (except 0x20 to CMM by default) will cause incor-
rect behavior.
Platform Event
Note: The command “Platform event” is only available from Linux
driver side. IPMC would only accept this command from Addin
card, and drops messages from CMM with bridged format.
Because IPMC only send this command to CMM, IPMC don’t
receive this command coming from outside.
ipmitool ipmitool [parameters] raw 0x04 0x01
Terminal mode [10 00 01]
Description Get event receiver’s slave address
1
Completion code
2
Slave address
3 [7:2] = reserved
[1:0] = Event receiver LUN
ipmitool
ipmitool [parameters] raw 0x04 0x02 0x04 0x01 0x01
0x01 0x07 0xFF 0xFF 0x48
Terminal mode [10 00 02 04 01 01 01 07 FF FF 48]
Description
Send event to event receiver. We don’t need to fire this
command directly.
This command can be testing when we test sensor event.