Acrosser ACE-MINI - Manual (Page 30)

Revision: 1.0
30
3.3 Connectors and Jumpers Setting
3.3.1 Locations
Note:
1. ＊ for ACE-B2019A only.
2. AR-B2009 functions please refer to chapter 4.
JP6
Bill enable, Coin enable and Hopper sensor pre-set
header.
JP2
AGA power supply header. *
SW4
8-bit readable DIP switch.
JP11
COM3 can be selected as RS232 serial port or
ccTalk2.
*
U3
i-Button holder. *
JP10
COM2 can be selected as RS232 serial port or
ccTalk1.
*
BAT1
BAT1 is rechargeable battery connector for AGA, RTC,
and SRAMB.
*
ccTalk2
ccTalk connector ( Signal share with COM3). *
JP3, JP14
SRAM A, SRAM B clear pin header. *
ccTalk1
ccTalk connector ( Signal share with COM2). *
CN1
Case Intrusion Switch.
COM2
RS232 Serial Ports COM2. *
CN6
Reel Controller Connector (44pin mini-IDE Reel
Connector connects to AR-B2009).*
CN8
RS232 Serial Ports COM3. * (JST 2.0mm 2×5)
CN3
CR2032 Battery Holder.
JP9
Selection of COM1 output voltage level is RS232C or
TTL.
*
JP13
Power on-off detect header. *
COM1
RS232 Serial Ports COM1. *