beautypg.com

General there is no sound, Sound is emitted from one speaker oniy, The output sound is not stereo – Aiwa CX-NV8000 User Manual

Page 24: An erroneous display or a malfunction occurs, Tuner section, There is constant, wave-like static, Cassette deck section the tape does not run, The sound is off-balance or not adequately high, Recording is not possible, Erasure is not possible

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TROUBLESHOOTING GUIDE

PARTS INDEX

If the unit fails to perform as described in these Operating
Instructions, check the following guide.

GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there a bad connection? (-> page 3)
• There may be a short circuit in the speaker terminals.

-► Disconnect the AC cord, then correct the speaker

connections.

• Was an incorrect function button pressed?

Sound is emitted from one speaker oniy.

• Is the other speaker disconnected?
The output sound is not stereo.
• Is the Karaoke function turned on? (-> page 17)
An erroneous display or a malfunction occurs.

-» Reset the unit as stated beiovy.

TUNER SECTION
There is constant, wave-like static.
• Is the antenna connected properly? (-► page 3)
• Is the signal weak?

-♦ Connect an outdoor antenna.

The reception contains noise interferences or the sound

is distorted.

• Is the system picking up external noise or multipath distortion?

Change the orientation of the antenna.

-r Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.
• Is deck 2 in pause mode? (-» page 11)
The sound is off-balance or not adequately high.
• Is the playback head dirty? (-» page 21)

Recording is not possible.

• Is the erasure prevention tab on the tape broken off? (-> page

12)

• Is the recording head dirty? {-* page 21)

Erasure is not possible.

• Is the erasure head dirty?

{-^

page 21)

• Is a metal tape being used?

High frequency sound is not emitted.

• Is a tape recorded without Dolby NR played back with the Dolby

NR system operating? (-» page 11)

• Is the recording/playback head dirty? (-♦ page 21)

CD PLAYER SECTION

The CD player does not play.
• Is the disc correctly inserted? (-+ page 9)
• Is the disc dirty? (-> page 21)
• Is the lens affected by condensation?

Wait approximately one hour and try again.

Instructions about each part on the main unit or remote control

are indicated on the pages listed below.

Parts

Pages

CD

9

CD EDIT/CHECK (EDIT/CHECK)

9, 15, 16

■ CLEAR

8, 9, 11

CLOCK

5

DEMO

5

DIGITAL ECHO

17

◄ ► DIRECTION/PRESET

8, 9, 11

DISC CHANGE

9

DISC DIRECT PLAY

9

DOLBY NR

12

DOWN

7, 9, 11

EDIT/CHECK (CD EDIT/CHECK)

9, 15. 16

FRONT SURROUND

7

GEO

6

KARAOKE (VOCAL FADER/MULTIPLEX)

17

KARAOKE ENTER

18

MIC 1, MIC2

17

MIC MIXING

17

±

OPEN/CLOSE

9

PHONES

6

POWER

5

PRGM

10

RANDOM

10

C/O)

REC/REC MUTE

13

REPEAT/MONO TUNER

7, 10

REV MODE (DECK 2)

11

II SET

8, 9

SLEEP

20

SYNC DUB NORM/HIGH

14

TAPE/DECK 1/2

11, 13

T-BASS

6

TIMER

19

TUNER/BAND

7

►M, ►► UP

7, 9, 11

VIDEO/AUX

21

VOCAL FADER/MULTIPLEX (KARAOKE)

17

VOLUME

6

0-9, -1-10

10

To reset

If an unusual condition occurs in the display window or the

cassette decks, reset the unit as follows.

1

Press the POWER button to turn off the power.

2 Press the POWER button to turn the power back on while

pressing the ■ CLEAR button. Everything stored in memory
after purchase is canceled.

If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord and repeat step 2.

23

ENGLISH