Aiwa CX-NV8000 - Manual (Page 12)

I
BASIC OPERATIONS
DIRECTION/
PRESET
DOWN
UP
PLAYING BACK A TAPE
Insert a tape.
1 Press the DOLBY NR button and turn Dolby NR
on or off to match the playback tape.
□□NR
(Sn -
Deck 2
For tapes recorded with DOLBY NR, turn on □□ NR.
For tapes recorded without DOLBY NR, turn off □□ NR.
2 Press the button to start play.
The tape counter indicates
the tape running iength.
INSERTING TAPES
• On deck 1, tapes are aiways piayed back on both sides.
On deck 2, you can select a reverse mode to play back one or
both sides.
• Use Type I (normai). Type II (high/CrOa) or Type IV (metai)
tapes for playback.
Press the TAPE button and press the ^ EJECT mark
to open the cassette holder.
Insert a tape with the exposed side down. Push the cassette
holder to close.
To select a reverse mode (deck 2 only)
Each time the REV MODE button is pressed, the reverse mode
changes.
I ^ ^ CIO
Playback side of the tape
>: The front side is being played (forward).
When tapes are loaded in both decks
Press the TAPE button first to select a deck.
The selected deck number is displayed.
To stop play, press the ■ button.
To pause play (deck 2 only), press the II button. To resume
play, press again.
To change the playback side, press the DIRECTION/
PRESET button in play or pause mode.
To fast forward or rewind, press the ◄◄ or ►► button in
stop mode. Then press the ■ button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE button. The power is turned on and play of the
inserted tape begins.
To set the tape counter to 0000
Press the ■ CLEAR button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
To play one side only, turn on d.
To play from front side to back side once only, turn on
1').
To play both sides repeatedly, turn on CZD.
• When tapes are loaded in both decks, in the display
indicates Continuous Play.
MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
When the ^ indicator of the button is flashing, press
the ►► button to move to the next track or the
MM button to
move to the beginning of the current track.
When the ◄ indicator of the button is flashing, press
the ◄◄ button to move to the next track, or the ►► button to
move to the beginning of the current track.
The search function uses a music sensor that may not be able
to detect tracks for tapes with:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels
1 1
ENGLISH