Preparation, To check the specified time and source, Timer recording – Aiwa CX-NV8000 User Manual

Page 20: To cancel timer standby mode temporarily, Using the unit while the timer is set, Setting the timer 3 1,2

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE TIMER

3
1,2

The unit can be turned on at a specified time every day with the

built-in timer.

The duration for the timer-activated period can be set between

10 and 240 minutes in 10-minute steps.

• If this step is not completed within 4 seconds, repeat from

step 1.

Prepare the source.

To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.

Press the POWER button to turn the unit off after

adjusting the volume and tone.

Mil

gyiBiiaii

When the timer-on time is reached, the unit turns on and
begins play with the selected source.

Preparation
Make sure the clock is set correctly. (See page 5.)

Use the remote control.

1 Press the TIMER button on the remote control

once to display 0, and press the II SET button

within 4 seconds.

is displayed, and the hour flashes.

To check the specified time and source

Press the TIMER button on the remote control. The timer-on

time and the selected source name are displayed for 4 seconds.

However, the duration for the timer-activated period will not be

displayed.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with

an external timer) sources only.

If you do not press the 11 SET button within 4 seconds, another

operation may start.

Designate the hour of the timer-on time by

pressing

the

DOWN

button,

and

the II SET button. Repeat to designate the minute
of the timer-on time.

After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.

3 Within 4 seconds, press one of the function

buttons to select a source.

“TIMER” and the selected source name flash alternately for 4
seconds. At this time, the selected function button does not

light up.

• If this step is not completed within 4 seconds, repeat from

step 1.

• If the TUNER button is pressed, the band cannot be selected

in this step.

4 Within 4 seconds, select the duration for the

timer-activated period with the DOWN or

UP button.

Press the TIMER button twice on the remote control so that
® appears on the display, and press the II SET button within

4 seconds. Repeat the steps shown above from step 2 and

insert the tape to be recorded into deck 2 after step 5.

To cancel timer standby mode temporarily

Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.

' Timer playback and timer recording will not begin unless the

power is turned off.

' Connected equipment cannot be turned on and off by the built-

in timer of this unit. Use an external timer.

Ipiil

ENGLISH