Lamp replacement – Ask Proxima DP9250 User Manual

Page 48

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

LAMP REPLACEMENT

If the lamp fails to come on and the lamp moniior on the projector light is orange, you must replace the bulb,

• For continued safety, replace with a lamp assembly of the same type.

♦ Allow the projector to coo! for at least 45 minutes before you open the lamp cover. The

inside of the projector can become very hot.

♦ Do not drop the lamp module or touch the glass bulb ! The glass can shatter and cause

injury.

Follow these steps to replace the lamp assembly.

1. Turn off the projector and allow the projector to cool thoroughly.

2. Disconnect the AC cord from the projector.
3. Remove screw with a screwdriver and disconnect the lamp cover.

4. Remove 2 screws with a screwdriver and pull out the lamp assembly by

grasping the handle,

5. Replace the lamp assembly.
6. Tighten 3 screws to secure the lamp cover to the lamp assembly.
7, Connect the detachable AC cord to the projector.

LAMP REPLACEMENT
INDICATOR

8. Reset the lamp replacement monitor timer. (See ’’LAMP AGE" section on page 46.)

NOTE;

Do not reset the LAMP REPLACEMENT MONITOR TIMER, except after the lamp is replaced.