Using the projector, Raturn qn the projegtor, O turn off the – Ask Proxima DP9250 User Manual
Page 27: Direct orerafldn mode select (top control)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
c
USING THE PROJECTOR
raTURN QN THE PROJEGTOR
bonnect the projector to a source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriat«
terminals on the rear of the projector (See "CONNECTiNG THE PROJECTOR" section on pages 10-17).
Connect the projector’s AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the rear of thi
projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light GREEN.
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector to ON. The LAMP POWER indicator light will dim and the cooling fans wilt
operate. The wait display appears on the screen and the count-down starts
(20-19-18-...1). The signal from the source appears after 30 seconds.
i«. THIS™OJECTOR USES
TO EXTEND THE LIFE OF THE LAMP, ONCE
YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
NOTE:
TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
if the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1). Press LAMP POWER ON/OFF button to OFF.
■
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner (See "AIR FILTER CARE AND CLEANING” section on page 47.)
■
(4). Press LAMP POWER ON/OFF button to ON.
b
if the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
'statìon.
O TURN OFF THE
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector. The "Power off ?” appears on the screen. Press again the LAMP POWER
ON/OFF button to turn OFF the projector. The LAMP POWER indicator will light bright
and READY Indicator will turn off. The cooling tans will operate tor 1 minute after the
projector is turned off. (During this "cooling down" period, the projector cannot be
turned on.) The READY indicator will light green again and the projector may be turned
on by pressing the LAMP POWER ON/OFF button. To power down completely, turn
the MAIN ON/OFF switch (located on the rear of the projector) to the OFF position.
DIRECT ORERAfLdN
MODE SELECT
(Top control)
Press the COMPUTER button located on the projector to select Computer 1 or
Computer 2 Input. The "Computer 1” or "Computer 2” display will appear on the Wipr'*'’'*
screen for a few seconds.
Press the VIDEO button located on the projector to select Video 1 or Video 2 Input.
The 'Video 1” or "Video 2" display will appear on the screen for a few seconds.
MODE SELECT
(Remote control unit)
Press the MODE button located on the remote control unit to select Computer 1,
Computer 2, Video 1 or Video 2 Input. The "Computer 1", "Computer 2 ” Video 1" or
"Video 2” display will appear on the screen for a tew seconds.
-" '■Vrdeb:i2..
■ Computer.2
...... 'T'"'
■Videó-'i:.-
•27 —