Ask Proxima DP9250 - Manual (Page 36)

AUTO IMAGE FUNCTION (COMPUTER MODE)
The Auto image function is provided to auiomatically adjust Fine sync.. Total dots and Screen position tor mos
computers. ^
1. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.
2. Press the POINT LEFT/RIGHT BUTTON(s) to select AUTO IMAGE and press the SELECT BUTTON. Anothe
dialog box AUTO IMAGE SETTING DISPLAY will appear.
3. Press the POINT DOWN BUTTON and a red arrow will appear,
4. Move the arrow to an item(s) you want to adjust by pressing the POINT UP/DOWN BUTTON(s),
5. Change the setting "On", press the SELECT BUTTON.
6. Move the arrow by pressing the POINT UP/DOWN BUTTON(s) to select “Go!" and then press the SELECT
BUTTON. The auto image function is started now. It will take about 10 seconds.
7. To store the settings, move the arrow to Stored and then press the SELECT BUTTON. When you have stores
the settings, ”OK?" is displayed for confirmation.
8. Move the arrow to Yes and then press the SELECT BUTTON. The stored settings are permanently held even i:
the MAIN ON/OFF is switched off.
9. To quit the MENU, point to Quit and then press the SELECT BUTTON.
10. This setting is temporarily effective until you turn off the projector or change the input signal.
NOTE; The fine sync., iotaf dots and screen position of same computers may not be fully adjusted with the "Autc
image Function”. In that case, use the "Picture Image” and/or "Picture Position” adjustments (see pages 37 -
38) to make fine-adjust them after the "Auto image Function” is executed.
MAIN MENU DISPLAY
AUTO IMAGE SETTING
DISPLAY
— .