Ask Proxima DP2300 - Manual (Page 44)

Chapter 3 • Using the Desktop Proiector
SETTINGS
This control allows you to retrieve rlie factory—set or stored
settings, or to save the current settings.
Store Settings
The default value for STORE SETTINGS is NO. If you wish to
save the current settings, use the Up or Down arrow 'ksy to select
YES. The new values become the stored settings under the
RETRIEVE SETTINGS option. These settings are retained when
the projector is turned off and will be in effect when it is turned
back on again.
You can also use STORE SETTINGS in any of the projector s
various video modes (i.e., VGA, Macintosh II, etc.). In each case,
the current settings can be stored for every entry available in the
SOURCE box.
Setrieve Settings
The RETRIEVE SETTINGS option is located in the right
portion of the SETTINGS box. To access the RETRIEVE
SETTINGS option, go to the STORE SETTINGS box and press
the Right arrow key. Three sets of settings can be retrieved:
• CURRENT - Settings in effect before you selected
RETRIEVE SETTINGS. If you select CANCEL, you will
return to the current settings.
• STORED - Settings whose values you have previously
stored. If the STORED entr)'- is grayed out, there are no
user-stored settings available.
• FACTORY - The built-in default settings for each video
mode.
3-0 * User’s Guide