Lamp replacememt indicator, Lamp, Order replacement lamp – Ask Proxima Ultralight LX User Manual

Page 35: Lamp replacement monitor timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

API

LAMP REPLACEMEMT Indicator

Wfien Ifie Lamp of this projeciordraws'to an“'ehci, the LA'MP'RE'PLACEMENT indicator lights yellow. VVher

image become dark or the color of the Image become

unnatural,

replacement

of the Lamp is required.

LAMP

CAUTION

♦ For

continued safety, replace with a

lamp assembly of the same type.

• Allow the projector to cool for at least 4S minutes before you open the lamp cover. The inside of the рго]<

can become very hot.

V Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

Turn off the projector and disconrrect the AC plug. Allow the
projector to cool for at least 45 minutes.

Remove a screw with a screwdriver and remove the lamp cover.

Remove 2 screws with a screwdriver and pull out the lamp

assembly by grasping the handle.

Replace the Lamp Assembly and tighten 2 screws. Maks sure

that the Lamp Assembly is set property. And replace the Lamp
Cover and tighten a screw.

Connect the AC Power Cord to the projector and turn the projector
on.

Reset the Lamp Replacement Monitor Timer (refer to the section
“Lamp Replacement Monitor Timer" below.)

NOTE: Do not reset the LAMP REPLACEMENT

MONITOR TIMER, when the lamp is not replaced.

ORDER

REPLACEMENT

LAMP

Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the foltowir
information to the dealer.

• Model No. of your projector : ULTRALIGHT LX

• Replacement Lamp Type No. : POA-LMP19J

^Service Parts No. S10 273 3896)

Lamp Replacement Monitor Timer

Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the La
Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops to lighting.

J Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the PO

LEFT/RIQHT buttons to select SETTING

and press the SELECT button (refer to the page 32). Anot

dialog box SETTING MENU Menu will appear.

Press the POINT DOWN button and a red-arrow icon will appear. Move the aiTow to Lamp age, and then press

SELECT button. The message of "Lamp replace monitor Reset?“ is displayed.

^ Select [Yesj to reset the Timer.

Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.