I-urnincdnujfffhem^ojegtor, Turning on the projector, Turning off the projector – Ask Proxima Ultralight LX User Manual
Page 21: Terminals of the projector, Basic operations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BASIC OPERATIONS
i-URNINCDNUJFFfHEM^OjEGTOR
Turning on the Projector
;
Complete the peripheral connections (with Computer, VCR, and
etc.) before turning on the projector. (Refer to "CONNECTING TO
THE
PROJECTOR“
on
Pages
10-15
for
connecting
those
equipment
Connect the projector's AC power cord into a wall outlet. The
LAMP POWER indicator lights RED, and the READY indicator
lights GREEN.
Press the power ON-OFF button on the Remote Control Unit or on
the Top Control to ON. The LAMP POWER indicator dims, and
the Cooling Fans start to operate. The Preparation Display
appears on the screen and the count-down starts. The signal
from the source appears after 30 seconds.
t— _______ I____
The Preparation Display disappears after 30 s<
Turning off the Projector
Press the power ON-OFF button on the Remote Control Unit or on
the Top Control, and the message “Power off?“ appears on the
screen.
Press again the power ON-OFF button to turn off the projector.
The
LAMP
POWER
indicator
lights
bright
and
the
READY
indicator turns off. The Cooling Fans operate for 90 seconds after
the projector is turned off. (During this “Cooling Down* period, this
appliance cannot be turned on.)
When the cooling the projector has finished, the READY indicator
turns to green again and you can turn the projector on. To power
down completely, disconnect the AC power cord.
i PjW-.r cff'’
The message disappears after 4 seconds.
A
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU TURN IT ON. WAIT AT LEAST 5 MINUTES
BEFORE TURNING IT OFF.
When the TEMPERATURE WARNING indicator flashes red, the projector is automatically turned off. Wait
at feast 5 minutes before turning the projector on again.
If the TEMPERATURE WARNING indicator coritinues to flash, follow procedures below:
1
. Disconnect the AC power cord from the AC outlet.
2. Check the air fitters for dust accumulation.
3. Clean the Air Filter. (See “AIR FILTER CARE AND CLEANING' section on page 33.)
4. Press the power ON-OFF button to ON.
If the TEMPERATURE WARNING indicator still continues to flash, calf your authorized dealer or service
station.
NOTE : The Coolirrg Fan may work for cooling while the projector is turned off. When the Cooling Fan Is
working, TEMPERATURE WARNING INDICATOR flashes red.