Drawer kick-out connector – Citizen Systems CBM-253 User Manual

Page 42

CBM-253 User’s Manual

CITIZEN

DRAWER KICK-OUT CONNECTOR

(1) Drawer kick drive signal

The specified pulse will be output according to the specified pulse generating command (ESC

). When

using the parallel interface. it will be possible to determine the condition of the drawer opening and closing

switch from pin 34 of the interface connector. When using the serial interface. the switch condition may be

determined by utilizing the peripheral equipment status sending command (ESC ).

(2) Electrical characteristics

Driving voltage : DC 24V

Driving current : Maximum 1A (Should be less than 510 ms)

SW signal

: Signal level

'L' = 0~0.5V

'H' = 3~5V

(3) Connector' s pin configuration

Connector pin

Signal name

Input/Output

Function

1 FG –

Frame

ground

L1 Output

Drawer

Input

Drawer opening and closing switch (* l)

–

Driving power source

L2 Output

Drawer

6 GND –

Signal

ground

Used connector

285D-3660J- 100 (DDK)

Suitable connector

285D- 1660P-I06 (DDK) equivalent product

Note: It will not be possible to switch both drawer 1 and 2 to ON at the same time.

Note: Drawer operation will not be possible while the printer is printing.

Note: The duty should be kept to 20% or less.

Note: This connector is not to be used for connection to telephone lines.