Citizen Systems CBM-253 - Manual (Page 25)

CBM-253 User’s Manual
13 CITIZEN
3.2 Explanation of each part
1 Power plug This plug should be inserted into a power source outlet of the specified voltage.
2 Power switch By setting this switch to ON, the printer initializati on operation will begin.
3 Power lamp This lamp will be lit when the power switch is ON, and will be off when the power
switch is OFF.
4 Alarm lamp This lamp will light in the printer error condition. The lamp will flash to indicate
the printer condition during errors such as when the paper has run out, when the
head is open, or when the head is overheating, and will also flash when the printer
is in the condition of waiting for macro execution, etc.
Error display patterns
Error name Pattern of flashing Conditions for resetting
Printer cover open
Head up
Paper near-end Close the cover
Head down
Set the paper
Paper end Set the paper
Label detecting error
Set the specified label paper and then
switch the power on a again
Memory checking error Resetting not possible *1
Head thermistor error Resetting not possible *1
Head overheating
Automatic resetting when the
temperature lowers
Cutter motor locking Resetting not possible *1
Waiting for macro execution
Waiting for label ejection
Waiting for test printing
Waiting for cutter operation
Press the LF switch
* 1 Contact service person.
Lit
Off
Lit
Off
Lit
Off
Lit
Off
Lit
Off
Lit
Off
Lit
Off
Lit
Off