Aiwa CX-N4000 U - Manual (Page 56)

RECORDING
Al EDIT RECORDING
ID
To clear the edit program
Before recording, press the B CLEAR button twice so that EDiT in the
dispiay goes out, or press the ^ OPEN/CLOSE button.
To check the edit program
Before recording, press the CD EDIT/REMAIN button.
The program for one side of the tape is displayed each time the
button is pressed. -> H
DISPLAY
® Time remaining on the tape
(2) Tape side
(D Total number of programmed tracks
@ Program tracks
To check the order of the programmed tracks
Before recording, press the CD EDIT/REMAIN button to select side
A or B, and press the DOWN or ►► UP button repeatedly.
Each time the button is pressed, the next track (►► button) or
previous track button) in the program is shown in the display.
^ID
DISPLAY
® Program number
@ Track number
To add tracks to the edit program
If there is any time remaining on the tape after step 5, you can add
tracks from other discs in the CD compartment before recording
starts.
1 Press the CD EDIT/REMAIN button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numeric buttons to select tracks.
PRGM flashes in the display.
If the playing time of a selected track is longer than the
remaining time, it is not added.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The total playing time of the edited tracks may be a little longer than
the specified tape recording time, because cassette tapes gener­
ally have a bit more tape than the time indicated on their labels.
In this case, the excess time (without the minus mark) is displayed
after editing instead of the remaining time (with the minus mark).
56