Aiwa CX-N4000 U - Manual (Page 40)

TAPE PLAYBACK
BASIC OPERATIONS
: H P h
Information in the display - *
ES
@ Playback side of the tape
When > is displayed, the side facing you (the front side) is
played.
When <1 is displayed, the other side (the side away from you)
is played.
(D Tape counter
The tape counter indicates the tape running length.
To change the playback side
During play or in pause mode, press the DIFVPRESET
button.
Each time the button is pressed, the playback side changes.
To set the tape counter to 0000
In stop mode, press the ■ CLEAR button.
The counter is also set to 0000 when a cassette holder is opened.
Usable tapes
Use normal (type I), Cr02 (type II) or metal (type IV) tapes.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum playback of a tape recorded with the Dolby NR
system, press the DOLBY NR button to turn the □□ NR indicator on.
NOTE
Noise may be heard if a television set is on nearby. Turn off the
television or separate the television from this unit.
m
WDOWN UPW
1.
SEARCHING FOR THE BEGINNING OF A
TRACK
(MUSIC SENSOR FUNCTION)
If there is a 4-second or longer blank between each track, you can
search easily for the beginning of a track during playback.
The search can be made in the forward or reverse direction.
According to the direction of the lighted indicators on the ◄►DIR/
PRESET button, press the ◄◄ DOWN or ►► UP button during
playback to move to the next track or play the current track. -> Q]
Refer to the table below for search directions.
◄ ► DIR/PRESET
button indicators
Next track Current track
/1''
►►
•4 <4 ►►
NOTE
The search function uses a music sensor, which may not be able
to detect tracks for tapes with
• blanks of less than four seconds between tracks.
• noisy blanks.
• long passages of low-level sound.
• low overall recording levels.
40