Release spring slip spring – SINGER 251 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
39
OIL-REMOVING WICK ASSEMBLY (continued)
RELEASE SPRING
SLIP SPRING
Fig. 61. Disassembly of Oil
Removing Wick
(Showing Oil-Removing Wick)
Wick Holder Body and Spring
147108)
Removing Wick (with Holder)
in Assembly 147056
DISASSEMBLY-
1.
Release end of spring from catch on the holder
body
04,
as instructed in
Fig. 61.
2.
Remove hinge screw, as instructed in
Fig. 61.
3.
Oil-removing wick and holder
N4
may then be
removed
from
hinge
plate
and
cover
L4,
as
shown in
Fig. 61.
CAUTION:
Before
inserting
a
new
oil
removing
wick,
it must be saturated with oil.
ASSEMBLY-
(See Fig. 62)
1.
Insert
open end
of holder body
04,
(with new
Wick) into hinge plate and cover
L4.
2.
Replace and securely tighten hinge screw as in
structed in
Fig. 62.
3.
Slip end of spring into catch on holder body
04,
as instructed in
Fig. 62.
4.
Place gasket
P4
on hinge plate and cover
L4.
5.
Align the screw holes in the gasket
P4
with the
screw holes in the cover
L4
and insert the four
screws
K4, Fig. 66, page 41
through cover and
gasket to hold the gasket in place.