Changing the light bulb, Replacing the slide plate – SINGER 514 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CHANGING THE LIGHT BULB
CHANGING THE BUIB
CAUTION:
Disconnect poworU/ne
plug from eiecirica! supply before re^
moving light bulb,
0 Lower light bracket with finger grip.
Removing the Bulb:
Do not attempt to unscrew ballx Press it
up into socket and turn it in 'unlock'
direction, as shown, and withdraw.
Replacing the Bulb:
Press new bulb into socket with bulb pin
entering slot of socket, and turn it over in
lock' direction shown to lock bulb in
position. Push bracket back into recess.
This machine is designed to use a 20
watt maximum light bulb.
REPLACING THE SLIDE PLATE
You will not have any occasion to remove
the slide plate. However, if it should
accidently become disengaged from the
machine, it is easily replaced,
# F^aiso the pressor foot and the needle.
# Place slide plate in slide Vv^ay with the
front edge close to, but not covering,
the retaining spring (as shown).
# With a screwdriver, lift each end of the
spring into each of the side grooves on
the underside of the plate,
# DravsT the plate gently toward you and
fully engage the spring,
# Close slide plate.
RgpiAciNG
r m m m
plate
Lift Retaining
6 3