Turning square corners – SINGER 514 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEWING THE PROFESSIONAL WAY (Continued)
PIVOTING AT CORNER
Turning Square Corners
To turn a square corner 1,6cm (I'-) from
the fabric edge, you need not measure or
mark the seam, Siniply use the crosslines
on the slide plate,
O Line up your fabric with right or left
guideline 6 on the needle plate. Stitch
seam, slowing speed as you approach
corner,
# vStop stitching, with the needle down,
when the bottom edge of the fabric
reaches the cornering crosslines on the
slide plate,
# Raise presser foot and turn fabric on
needle, bringing bottom edge of fabric
in line with guideline 6.
#
Lower the presser foot and stitch in
new direction.
ENDING A SEAIVI
1.
Stitch to the fabric edge. Depress
fully reverse push button and hold in
place: backstitch approximately 1cm
to reinforce end of seam>
Release push button.
2. Turn hand wheel to bring needle to
its highest point,
3. Raise presser foot and remove fabric
by drawing straight back.
4. Cut threads on thread cutter at rear
of presser bar.
32