Darning with embroidery hoopt, Jl, j x j jl – SINGER 514 User Manual

Page 60

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

KEEPING UP APPEARANCES (Continued)

Feed Cover Needle Plate

V...

Darning with Embroidery Hoopt

Patlom Soloctor; Any setting

Fiexi-Stkch Dial: 0

stitch Width: l i l i 1 1 ^

Needle Position:

jL, j X j Jl

Stitch Length: 1-0

Feed Cover Needle Plate

No Presser Foot
Pressor Bar: Lowered

Preparation
Roniovo presser foot with shank and

attach feed cover needle plate. Instruc-
lions for changing the needle plate are
given on page 8.

1. Trim ragged edges from area to be

darned.

2. Centre worn section in embroidery

hoop.

3. Position work under needle over feed

cover plate and lower presser bar to
engage temion.

4. Hold needle thread loosely with left

hand, turn hand wheel over and draw
bobbin thread up through fabric> Hold

both thread ends and lower needle
into fabric.

B. Outline area to be darned with running

stitches for reinforcement,

6> Stitch across opening, moving hoop

under needle at a slight angle from
lower left to upper right. Keep lines of
stitching closely spaced and even in
length,

7, When opening is filled, cover area with

crosswise lines of stitching.

This method of controlling fabric move

ment with an embroidery hoop may be
used to do embroidering or mono-
gramming.

tTho Darning and Embroidery Hoop is avail

able for separate purchase at your Singer
Sewing Centro.