Changing presser feet – SINGER 514 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Changing Presser Feet

1. Raise the prosser foot and make sure

the needle Is at Its highest point.

2. With youf thumb under the prosser

foot and your Index finger at the back,

tilt prosser foot away from you and

remove it.

3. Centre the new pressor foot under the

shank and hold it in position,

4. Lower die presser bar so that the

front opening in the shank fits over
the pin in the presser foot.

b. Press down on the presser foot screw

until the foot snaps into place.