Treadle drive, Dual purpose electric/treadle drtve, Electric drive – SINGER 514 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TREADLE

DRIVE

# Loosen hand wheel knob.

# Place feet on tfeadle.
# Turn hand w4ieel over toward you and

allow feet to move freely and lightly

with motion of treadle.

# Practice this motion until you are able

to redstart machine v/ith hand wheel
turning over toward you<

# Tighten hand wheel knob.

# For light, insert machine plug and

connect wall plug. Switch on light,

# Place material under presser foot and

lower the presser foot.

# Operate machine (without thread} until

you become accustomed to guiding
the material

# To disengage belt—operate treadle

and throw-off belt to the right.

# To engage belt—operate treadle with

hand wheel turning toward you and
guide belt on to band wheel

NOTE; Belt tension should be only

heavy enough to keep belt

from slipping.

DUAL PURPOSE

ELECTRIC/TREADLE DRtVE

Electric Drive

CAUTION: Before insermg machinem

plug and wall plug (he beh for treacHe |

drive must be disengaged as instructed |
above,

# Operate the machine as instructed for

electric drive on page 10.

Treadle Drive

# Disconnect rnachine/controller plug

from machine and wall plug from

electrical outlet as shown. (If light

connection is required a special light

lead must be used—please consult

your SINGER Sewing Centre.)

# Operate machine as instructed above.

DISENGAGING HAND WHEEL

ENGAGING BELT DRIVE