Curved seams, Reinforcing end of seam – SINGER 2001 TouchTronic User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CURVED SEAMS
• Use a short stitch for elasticity and strength.
Use the stitch length control in the Digital
Fine Tuning section of the machine to obtain
a short stitch for curved seams. For addi
tional information on stitch length, refer to
Chapter 3 Electronic Sewing, page 29.
If you use the seam guide, attach it at an
angle so that the edge that is closer to the
needle acts as a guide.
Stitching a Curved Seam
REINFORCING END OF SEAM
• Stitch to the edge of the fabric. (Do not sew
beyond edge of fabric.)
• Touch I'l’ reverse stitch symbol while
sewing and hold in place. Backstitch ap
proximately 1/2-inch (1.3cm) to reinforce
end of seam. Release reverse stitch symbol.
• Raise needle to its highest position by turn
ing hand wheel toward you and raise presser
foot. Remove the fabric by drawing it to the
back and left.
i I
Reverse Stitching
• Cut threads on thread cutter at rear of
presser bar.
For additional information on reverse stitch
ing, refer to Chapter 3 Electronic Sewing,
page 32.
43