SINGER 2001 TouchTronic User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
We recommend the use of a moderate
speed when winding a bobbin.
1. Move bobbin latch A to extreme right.
2. Draw needle thread away from you bet
ween toes of presser foot, under left
side of presser foot, then up from the
front into and around thread retainer B.
Release thread end. Start machine, run
at moderate speed.
3. Pull thread end away after it has sepa
rated from bobbin.
•
• Watch the bobbin as it fills. Do not
allow thread to wind beyond the out
side FULL ring C.
4. Close slide plate to release bobbin
latch to sewing position.
To start sewing, pull thread back under
presser foot and cut. Place threads diagonally
under foot to left side, position needle in
fabric where desired, lower presser foot, and
start machine. For additional information on
starting to sew refer to Chapter 4, Straight
Stitching page 41.
24