SINGER 2001 TouchTronic User Manual
Page 111
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching a Button (Cont.)
4. Lower button foot.
• Turning hand wheel toward you, lower nee
dle close to button surface.
5. Adjust width, if necessary, until needle is
aligned directly above left hole in button.
6. Turn hand wheel toward you to take one
stitch in left hole, then continue to turn
hand wheel to carefully place needle in op
posite hole.
• Run machine slowly taking approximately
six stitches to secure button.
• Remove work from machine leaving 4 in
ches (10cm) of thread. Pull thread ends
through to inside of garment, and knot them
close to fabric to form a secure finish.
If sewing a series of the same buttons is
desired, after following the above procedure,
place garment and button under button foot.
Raise needle to position it over left hole of
button. Carefully place needle in left hole of
button and run machine slowly.
6
97