Cutting button opening – SINGER 2001 TouchTronic User Manual
Page 108
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Switch machine off.
Push buttonhole lever up as far as it will go.
Remove one-step buttonhole foot. Push back
A. Snap down B.
CUTTING BUTTON OPENING
• Place a pin across the cutting space at each
end of the buttonhole to protect bar tacks.
• Use a pair of small, sharp scissors to cut the
button opening.
• Insert blade in center of the buttonhole cut
ting space and cut from this point in both
directions.
Be sure to check that the button slides
through the opening on your test sample. To
adjust buttonhole cutting space, see page 95.
Cutting Button Opening
94
This manual is related to the following products: