Four-step buttonholing – SINGER 4022 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Four-Step Buttonholing
® Pattern Selector: As illustrated
® Stitch Width; 3»5 to suit fabric
® Stitch Length: F to 3
® General Purpose Needle Plate
® Buttonhole Foot
Preparation
® Attach buttonhole foot to the
machine. Refer to page 5 for addi
tional information on changing
presser feet.
1. Raise presser foot lifter. Hold
upper thread lightly with left hand
and turn hand wheel slowly
toward you until needle enters the
plate.
BE CAREFUL THAT YOU DO
NOT RUN THE MACHINE DUR
ING THIS PROCEDURE.
Continue turning hand wheel and
holding upper thread until needle
rises. Tighten your hold on upper
thread and bring up lower thread
in a loop. Release upper thread.
Slide scissors between foot A and
plate B and draw both upper and
lower threads diagonally toward
the back of the foot, leaving
approximately 10 cm (4 inches) of
thread.
® Set machine according to above
code.
2. Place fabric with buttonhole
marking lines under foot. Align
bar tack marking line C with
notches on the solid white section
of foot D.
A A