SINGER 4022 - Manual (Page 32)

\ <^ -a %
2 3 4
■ > « ^
6 0 i a AC o
-“• waaaaa AA/\^^
» «C* «4 «4 l^i» *««♦ »:«««<« K4№»>
Selecting a Pattern
Before moving stitch pattern selec
make sure needle is above tor,
fabric.
When you turn the stitch pattern
selector, one of eleven stitch
patterns is available to you. Turn
stitch width selector to 0. Then
rotate the pattern selector until the
desired stitch pattern number is
aligned with indicating line.
Adjusting Stitch Length
When you are preparing to do
pattern stitching, make a test sample
with the fabric and thread you plan
to use so that you can adjust the
stitch length correctly.
Any stitch length setting from 1 to 4
will give you an open stitch pattern
of whichever decorative stitch pat-
tern you select. The higher the
number, the more open, or farther
apart, your stitch will be. The area
between 0 and 1 of the selector is
used for the fine adjustment of satin
stitching.
For stretch stitch patterns, stitch
length is controlled with the setting
4 on the panel. Simply rotate the
selector until the selector is posi­
tioned at 4.
Adjusting Width of the Design
Before turning stitch width selector,
always raise needle above fabric.
To produce a stitch pattern, the
stitch width selector must be turned
from 0 toward a higher number. The
higher you turn the dial, the wider
your stitch will be.
.V.VVSV.SSW/
on