Nortel Networks NN42030-102 - Manual (Page 66)

Advanced features
4. After the call to the second party is established, select Options,
Swap from the Phone screen to alternate between the two parties.
Three-party conference call
1. While in a call with the first party, select Options, Hold.
The first call is placed on Hold
2. Dial or select the number of the person you want to call.
3. Select Options, Call.
You can wait until the second party answers, or you can connect the
second party while the call is still ringing.
4. Select Options, Conference.
The call on hold is transferred to a 3-party bridge and you can both
hear the second party .
Note: While you are in a three-party conference call, you can use a
variety of dialpad controls (for example *5). However, if any of the
participants are in a second conference call, the dialpad controls are
no longer available.
Cancelling a call with a call on hold
To cancel the active call leg, without hanging up on the party on hold,
from the Phone pane, select Options, Cancel.
Speaker mode
To switch from the ear piece speaker to the system speaker:
• While a call is connected, select Options, Turn on Loudspeaker.
To switch from the system speaker to the ear piece speaker:
• While a call is connected, select Options, Turn off Loudspeaker.
Handoff
Device handoff requires a Handoff key on your desktop telephone. If you
do not have this key configured, contact your system administrator.
NN42030-102 MC 3100 3.1 Standard 04.03 November 2009 66