Software installation – Nortel Networks NN42030-102 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Software installation

This section describes how to install, upgrade, and uninstall the Nortel

Multimedia Communication Client 3100 (MCC 3100) for Nokia on a

supported Nokia device. There are two ways to install or upgrade the

MCC 3100 for Nokia: from a computer or over the air.

Before you install or upgrade the MCC 3100 for Nokia software from a

computer, ensure that your Nokia device and your PC are connected

using a Universal Serial Bus (USB) cable and ensure that Nokia PC Suite

software is installed on your PC.

Note 1: Ensure that your device has the correct date and time.

Note 2: In some cases, it is necessary to remove the existing

software components prior to performing an upgrade. Check with
your system administrator or read the release notes before

proceeding with an upgrade.

Note 3: If you are upgrading from an earlier release, you must

perform an initial software installation, not an upgrade. After
reinstalling the software, change the MCG 3100 address on the

Systems Settings screen if instructed to do so by your system
administrator.

Note 4: If you wish to use Hypertext Transfer Protocol Secure

(HTTPS) with certificates, you should install the certificate prior to
installing the MC 3100 client.

Use the following procedures to install, upgrade, and uninstall the
MCC 3100 for Nokia software.

•

•

•

Nortel Mobile Communication Client 3100 for Nokia User Guide