Sears 917.25591 - Manual (Page 15)

mmm slides quiwe ielt
ICEWTER TO OUTER MaWORELSl
BELT ROUTING DECAL UNDER MOWER DECK COVER.
1. Remove Mower from Tractor (see below).
2. Remove Top Cover Seif Tapping Screws, and Nut from
Idler Arm Bolt
3. Roll Belt over the top of the R H. Mandrel.
4. Pull Belt off all other Mandrels.
5. Remove any dirt and grass which may have accumulated
around Mandrels and Idler Arm.
6. Check Deck Idler Arm Assembly and Flat Idler to see that
they rotate freely (Fig. 30).
7. Be sure spring is hooked in Deck Idler Arm Assembly and
on bolt in Mower Housing (Fig. 30),
8. Install new Belt in groove of L.H. Mandrel Sheave, lower
groove of Center Mandrel Sheave and around Flat Idler as
shown (Fig. 30).
9. From a position at discharge end of mower, roll Belt into
groove of R H, Mandrel Sheave (Fig 30),
10. Rotate Center Mandrel Sheave by hand to make sure Belt
is in grooves properly,
A
BLADES WILL ROTATE WITH CENTER
MANDREL SHEAVE.
11. Reassemble Top Cover to Deck, Tighten all Screws secure­
ly.
12. Install Mower to tractor (see page 8)
ЯЕМ0¥§Ш6 МОШЕР
FROM ТРАСТОВ
1. Lower Mower
2 Pull the four (4) Release Pins out of Suspension Brackets
(Fig 31),
3, Pull back on Attachment Lift Handle and lock into place.
4 Slide Mower forward and remove Belt from Primary Man­
drel.
5. Raise Attachment Lift Handle. Sftda Mower out from undra"
tractor.
ilDLER ABM
¡NUT
CENTRAL MANDREL SHEAVE
FLAT IDLER
L.H. MANDREL ‘
SHEAVE
R.H. MANDREL
SHEAVE
FIGURE 30
-15